Explosion Damage Assessment and Formula Fitting of Prestressed Concrete Box Girder
CSTR:
Author:
Affiliation:

College of Civil Engineering, Tongji University, Shanghai 200092, China

Clc Number:

U441;TU312

  • Article
  • | |
  • Metrics
  • |
  • Reference [25]
  • |
  • Related [20]
  • | | |
  • Comments
    Abstract:

    In this paper, the explosion damage assessment of prestressed concrete box girder is studied. First, the numerical analysis model of rectangular beam explosion is conducted, and the accuracy and reliability of the explosion numerical model is verified by the field test results. Then, based on the residual bearing capacity of the structure, the damage assessment criterion of box girder at explosion load is established. By analyzing the residual bearing capacity of box girders at explosion load, the P-I (pressure–impulse) curves of various damage degrees of box girders are determined. The results show that the concrete strength has a greater influence on the critical value of overpressure and impulse, while the yield strength of reinforcement has less influence. With the increase of damage grade, the influence amplitude of each parameter on P-I curve of box girder is different. Finally, the formula fitting of P-I curves of all damage grades of box girder with different concrete strength is performed, and the fitting parameter β is analyzed.

    Reference
    [1] 杜刚.爆炸荷载作用下钢筋混凝土T梁桥和箱梁桥的动态响应研究[D]. 武汉:武汉科技大学,2018.DU Gang. Dynamic analysis of reinforced concrete T and box girder bridge subjected to blast load[D]. Wuhan: Wuhan University of Science and Technology,2018.
    [2] 蒋志刚,王赞,严波,等.爆炸荷载作用下悬索桥竖弯响应的数值模拟[J]. 振动与冲击, 2012, 31(2):123.JIANG Zhigang, WANG Zan, YAN Bo, et al. Numerical simulation for vertical bending response of a suspension bridge under air explosion loading[J]. Journal of Vibration and Shock, 2012, 31(2):123.
    [3] TANG E K C, HAO H. Numerical simulation of a cable-stayed bridge response to blast loads, part I: model development and response calculations [J]. Engineering Structures, 2010, 32(10): 3180.
    [4] HAO H, TANG E K C. Numerical simulation of a cable-stayed bridge response to blast loads, part II: damage prediction and FRP strengthening [J]. Engineering Structures, 2010, 32(10): 3193.
    [5] JARRETT D E. Derivation of the British explosives safety distances [J]. Annals of the New York Academy of Sciences, 2010, 152(1):18.
    [6] FALLAH A S, NWANKWO E, LOUCA L A. Pressure-impulse diagrams for blast loaded continuous beams based on dimensional analysis[J]. Journal of Applied Mechanics, 2013, 80(5):051011.
    [7] HAMRA L, DEMONCEAU J F, DENOEL V. Pressure–impulse diagram of a beam developing non-linear membrane action under blast loading[J]. International Journal of Impact Engineering, 2015, 86:188.
    [8] 田志敏, 章峻豪, 江世永. 钢板混凝土复合梁在爆炸荷载作用下的损伤评估研究[J]. 振动与冲击, 2016, 35(4):8.TIAN Zhimin, ZHANG Junhao, JIANG Shiyong. Damage assessment for steel-concrete composite beams subjected to blast loading[J]. Journal of Vibration and Shock, 2016, 35(4):8.
    [9] XU J, WU C, LI Z. Analysis of direct shear failure mode for RC slabs under external explosive loading[J]. International Journal of Impact Engineering, 2014, 69:136.
    [10] DRAGOS J, WU C, HASKETT M, et al. Derivation of normalized pressure impulse curves for flexural ultra-high performance concrete slabs[J]. Journal of Structural Engineering, 2013, 139(6):875.
    [11] SHIM C S, SHIN D H, YUN N R. Pressure-impulse diagram of multi-layered aluminum foam panels under blast pressure[J]. Journal of Engineering Science and Technology, 2013, 8(3):284.
    [12] MUTALIB A A, HONG H. Development of P?I diagrams for FRP strengthened RC columns[J]. International Journal of Impact Engineering, 2011, 38(5):290.
    [13] 陈俊杰, 高康华, 孙敖. 爆炸条件下结构超压?冲量曲线简化计算研究[J]. 振动与冲击, 2016, 35(13):9.CHEN Junjie, GAO Kanghua, SUN Ao. Simplified calculation method for pressure-impulse curve of a structure under blast load[J]. Journal of Vibration and Shock, 2016, 35(13):9.
    [14] HALLQUIST J Q. LS-DYNA keyword user’s manual(971) [R].Livermore:Livermore Software Technology Corporation, 2012.
    [15] SHI Y, HAO H, LI Z X. Numerical derivation of pressure–impulse diagrams for prediction of RC column damage to blast loads [J]. International Journal of Impact Engineering, 2008, 35(11):1213.
    [16] DOBROCINSKI S, FLIS L. Numerical simulations of blast loads from near-field ground explosions in air[J]. Studia Geotechnica et Mechanica,2015,37(4):11.
    [17] HALLQUIST J Q. LS-DYNA theory manual[R]. Livermore: Livermore Software Technology Corporation, 2006.
    [18] MALVAR L J, CRAWFORD J E, WESEVICH J W, et al. A plasticity concrete material model for DYNA3D[J]. International Journal of Impact Engineering, 1997, 19(9/10):847.
    [19] WU Y, CRAWFORD J E. Numerical modeling of concrete using a partially associative plasticity model[J]. Journal of Engineering Mechanics, 2015,141(12):04015051.
    [20] XU M, WILLE K. Calibration of K&C concrete model for UHPC in LS-DYNA[J]. Advanced Materials Research, 2014, 1081:254.
    [21] BETON E. CEB-FIP model code 1990[M]. London: Thomas Telford Publishing, 1993.
    [22] MALVAR L J, CRAWFORD J E. Dynamic increase factors for concrete[R]. Orlando: Twenty-eighth DDESB Seminar, 1998.
    [23] MALVAR L J, CRAWFORD J E. Dynamic increase factors for steel reinforcing bars[R]. Orlando: Twenty-eighth DDESB Seminar, 1998.
    [24] YAO S J, ZHANG D, LU F Y, et al. Damage features and dynamic response of rc beams under blast[J]. Engineering Failure Analysis, 2016, 62:103.
    [25] ZHANG D, YAO S J, LU F Y, et al. Experimental study on scaling of RC beams under close-in blast loading[J]. Engineering Failure Analysis, 2013, 33 :497.
    Cited by
    Comments
    Comments
    分享到微博
    Submit
Get Citation

LIU Chao, SUN Qixin. Explosion Damage Assessment and Formula Fitting of Prestressed Concrete Box Girder[J].同济大学学报(自然科学版),2023,51(6):874~883

Copy
Share
Article Metrics
  • Abstract:167
  • PDF: 645
  • HTML: 132
  • Cited by: 0
History
  • Received:November 30,2021
  • Online: June 28,2023
Article QR Code